Okuma & Howa Millac feed issue

[gainst]

Hi,
I have an issue with an older Okuma & Howa Millac 3VA with a FANUC Series O-M control.
the feed will not exceed 6.32IPM no matter what I program as the feed rate.
The feed rate override knob has no effect either. Any suggestions?

Similar Threads:

• Okuma Howa Millac 3VA - Fanuc 0M - Spindle Issue
• Okuma & Howa Millac 5V tool changer issue
• Need Help!- Millac 5V Okuma Howa
• Okuma & Howa Millac 8VA
• Okuma & Howa Millac 5VA